| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Curved bottom on Fender nuts http://www-.luthiersforum.com/forum/viewtopic.php?f=10137&t=50829 |
Page 1 of 1 |
| Author: | Tim Mullin [ Sat Jul 21, 2018 7:19 pm ] |
| Post subject: | Curved bottom on Fender nuts |
Not for the first time, I made a bone nut today for a vintage Fender guitar, cursed Leo and wondered “why did he have this bright idea that a nut should have a curved bottom”? So, I went to Google and looked for an answer — came up empty. Any one have any idea how this came about? Sent from my iPad using Tapatalk |
|
| Author: | Freeman [ Sat Jul 21, 2018 9:12 pm ] |
| Post subject: | Re: Curved bottom on Fender nuts |
I always assumed (you know thats a mistake) that they cut the nut slot after radiusing the f/b and whatever kind of router jig followed the radius. That's a pain for the nut but pretty nice if fret slots are the same depth all the way across. I believe that some of the after market necks have flat bottoms on the nut slots. |
|
| Author: | B. Howard [ Sun Jul 22, 2018 4:39 am ] |
| Post subject: | Re: Curved bottom on Fender nuts |
freeman got the reason correct, all slots cut after the board is radiused. A quick easy way to make a nut with a bottom that fits perfectly is to place a piece of stick on sandpaper on the FB between the nut slot and 1st and use that to sand the bottom to shape. Takes but a few seconds. |
|
| Author: | Tim Mullin [ Sun Jul 22, 2018 10:10 am ] |
| Post subject: | Re: Curved bottom on Fender nuts |
Sure, I can see that machining a slot with curved bottom during shaping of the neck is straightforward, but making a flat bottom is hardly difficult, and surely would be easier than making tiny nuts with accurately matched bottoms. My process has been to draw a radius on the thicknessed nut with an appropriate fret caul, rough out on my combo spindle sander, then finish on sandpaper over the FB. Not so quick that my mind doesn’t have time to ask ... why? Sent from my iPad using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|